User manual AEG-ELECTROLUX RF594G

[. . . ] Water connection • Make sure not to cause damage to the water hoses. €¢ Before you connect the appliance to new pipes or pipes not used for a long time, let the water flow until it is clean. €¢ The first time you use the appliance, make sure that there is no leakage. €¢ The water inlet hose has a safety valve and a sheath with an inner mains cable. [. . . ] ENGLISH 55 2) The appliance senses the degree of soil and the quantity of items in the baskets. It automatically adjusts the temperature and quantity of the water, the energy consumption and the programme duration. 3) This programme has a high temperature rinsing phase for better hygiene results. During the rinsing phase, the temperature stays at 70 °C for at least 10 minutes. 5) With this programme you have the most efficient use of water and energy consumption for crockery and cutlery with normal soil. Information for test institutes For all the necessary information for test performance. 2 Acoustic signals The acoustic signals operate when the appliance has a malfunction, when the adjustment of the level of the water softener occurs and when the programme is completed. By default, the acoustic signals are on, but it is possible to deactivate them. Make sure that the appliance is in setting mode, refer to “Setting and starting a programme”. 1 Multitab Activate this option only when you use the combi detergent tablets. Press and hold, at the same time, butand button until the ton Multitab indicator comes on. Press and hold, at the same time, button and button until all the programme indicators come on. Make sure that there is detergent in the detergent dispenser before you start a new programme. If you do not press the on/off button, the AUTO OFF function automatically deactivates the appliance a few minutes after the end of the programme. This helps to decrease the energy consumption, Important • Let the dishes become cold before you remove them from the appliance. €¢ First remove the items from the lower basket, then from the upper basket. €¢ There can be water on the sides and on the door of the appliance. Press the delay start button again and again until the display shows the delay time you want to set (from 1 to 24 hours). €¢ The delay time flashes in the display and the delay indicator comes on. €¢ When the countdown is completed, the programme starts. Opening the door while the appliance operates If you open the door, the appliance stops. When you close the door, the appliance continues from the point of interruption. [. . . ] 1 If the washing and drying results are not satisfactory Whitish streaks or bluish layers on glasses and dishes • The released quantity of rinse aid is too much. ENGLISH 63 Stains and dry water drops on glasses and dishes • The released quantity of rinse aid is not sufficient. Dishes are wet • The programme is without a drying phase or with a low temperature drying phase. €¢ The quality of the combi detergent tablets can be the cause. [. . . ]