User manual GE APPLIANCES JGBP33

[. . . ] . 29 JGBP24 JGBP25 JGBP26 JGBP27 JGBP28 JGBP29 JGBP30 JGBP32 JGBP33 JGBP34 RGB735 RGB740 RGB745 RGB746 RGB790 Write the model and serial numbers here: Model # ______________________ Serial # ______________________ You can find them on a label on the front of the range behind the storage drawer or kick panel. 183D5580P194 49-85109 07-06 JR Safety Instructions IMPORTANT SAFETY INFORMATION. READ ALL INSTRUCTIONS BEFORE USING. For your safety, the information in this manual must be followed to minimize the risk of fire or explosion, electric shock, or to prevent property damage, personal injury, or loss of life. WARNING! WARNING: If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or death. -- Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. -- WHAT Operating Instructions ® WARNING! ANTI-TIP DEVICE s ALL RANGES CAN TIP s INJURY TO PERSONS COULD RESULT s INSTALL ANTI-TIP DEVICES PACKED WITH RANGE s SEE INSTALLATION INSTRUCTIONS TO DO IF YOU SMELL GAS s Do not try to light any appliance. [. . . ] A sewing needle or wire twist-tie works well to unclog it. Use a sewing needle or twist-tie to unclog the small hole in the burner head. Front of range Large head and cap Large head and cap The slits in the burner heads must be kept clean at all times for an even, unhampered flame. Clogged or dirty burner ports or electrodes will not allow the burner to operate properly. Take care to not hit an electrode with anything hard or it could be damaged. You should clean the burner caps and burner heads routinely, especially after bad spillovers, which could clog the openings in the burner heads. To remove burned-on food, soak the burner heads in a solution of mild liquid detergent and hot water for 20­30 minutes. For more stubborn stains, use a toothbrush. Installation Instructions On some models: Medium head and cap Small head and cap Front of range Medium head and cap Large head and cap Troubleshooting Tips After cleaning Before putting the burner caps and heads back, shake out excess water and then dry them thoroughly by setting in a warm oven for 30 minutes. NOTE: Do not use steel wool or scouring powders to clean the burners. Make sure the slot in the burner head is positioned over the electrode. Consumer Support Replace the matching size caps onto the heads. Make sure that the heads and caps are replaced in the correct locations. NOTE: On some models, the burners are all the same size and power. 26 Safety Instructions ge. com Burner Grates Lift out when cool. When replacing the grates, be sure they are positioned securely over the burners. On models with professional-style double grates, the grates are position-specific. For maximum stability, these grates should only be used in their proper position; they cannot be interchanged left to right or front to back. For convenience, the undersides of the left and right grates are marked "LEFT FRONT" and "RIGHT FRONT. " Do not operate a burner for an extended period of time without cookware on the grate. To get rid of burned-on food, place the grates in a covered container. Although they are durable, the grates will gradually lose their shine, regardless of the best care you can give them. NOTE: Do not clean the grates in a self-cleaning oven. Operating Instructions Installation Instructions Cooktop Surface To avoid damaging the porcelain enamel surface of the cooktop and to prevent it from becoming dull, clean up spills right away. Foods with a lot of acid (tomatoes, sauerkraut, fruit juices, etc. ) or foods with high sugar content could cause a dull spot if allowed to set. For other spills such as fat spatterings, etc. , wash with soap and water once the surface has cooled. NOTE: Do not store flammable materials in an oven or near the cooktop. Do not store or use combustible materials, gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. Lifting the cooktop can lead to damage and improper operation of the range. Troubleshooting Tips Stainless Steel Surfaces (on some models) Do not use a steel wool pad; it will scratch the surface. To clean the stainless steel surface, use warm sudsy water or a stainless steel cleaner or polish. [. . . ] During this limited one-year warranty, Mabe will also provide, free of charge, all labor and in-home service to replace the defective part. Operating Instructions What Mabe Will Not Cover: s Service trips to your home to teach you how to use the product. s Failure of the product if it is abused, misused, or used for other than the intended purpose or used commercially. s Damage to the product caused by accident, fire, floods or acts of God. s Incidental or consequential damage caused by possible defects with this appliance. [. . . ]