User manual KENWOOD TK-D300

[. . . ] ⷠDo not disassemble or modify the transceiver for any reason. ⷠDo not expose the transceiver to long periods of direct sunlight, nor place it near heating appliances. ⷠDo not place the transceiver in excessively dusty, humid, or wet areas, nor on unstable surfaces. ⷠIf an abnormal odor or smoke is detected coming from the transceiver, switch the transceiver power off immediately, and contact your KENWOOD dealer. [. . . ] Preferred Channel + Talkback: If your dealer has programmed a Preferred channel, this channel is the revert channel. However, when paused on a busy channel, you are able to "talk back" on that channel until Scan resumes. However, when paused on a busy channel, you are able to "talk back" on that channel until Scan resumes. Scan Resume controls when the transceiver continues scanning after stopping due on a busy channel. ⷠTime-Operated Scan: After stopping on a busy channel, Scan resumes after a predetermined time (set by your dealer) whether or not the signal is still present on the channel. Carrier-Operated Scan: The transceiver remains on the busy channel until the signal ends. Scan resumes after a predetermined time (set by your dealer) after the signal has dropped out. A Selective Call, or Selcall, is a voice call to a particular station or group of stations. Depending on the Auto Reset time set up by your dealer, your speaker will mute if no reponse is received. You can unmute the speaker to remain in standby mode by pressing the # key or the key programmed as Monitor. If your dealer has programmed your transceiver with a list of stations, you can manually select a station to send a selcall. Status codes range from 10 to 99 (80 ~ 99 are reserved for special messages). Press the D> key to view the character message of the selected code, and the <C key to return to the code selection. 1 While in Selcall Mode, press the key programmed as Selcall to view the Selcall list. Begin your conversation by pressing the PTT switch and speaking into the microphone. ⷠDepending on the Auto Reset time set up by your dealer, your speaker will mute if no reponse is received. You can unmute the speaker to remain in standby mode by pressing the key programmed as Monitor. 2 Press the CH and keys to select the ID of the station you want to call. 1 While in Selcall Mode, press and hold the PTT switch, then enter the # key, key A to D (to select the respective memory location), followed by the # key again ⷠReleasing the PTT switch before entering the final # key will cancel the call. While making the call, the While making the call, the icon flashes and "SEND DATA" appears on the display. ⷠ"COMPLETE" appears on the display when the call has been successfully transmitted. Begin your conversation by pressing the PTT switch and speaking into the microphone. [. . . ] 2 Press the key to end the recording at any time and store it into the transceiver memory. ⷠIf the memory becomes full, recording will stop automatically and store the voice memo to memory. ⷠ"WRITING" appears on the display while the recording is being stored to memory. Key to cancel and return to normal · press the operation. [. . . ]