User manual PHILIPS AT891

[. . . ] charge and store the appliance at a temperature between 10°C and 35°C. Always place and use the shaver and the charging stand (AT891 only) on a surface that is fluidresistant. Always put the protection cap on the shaver to protect the shaving heads when you are travelling. If the shaver is subjected to a major change in temperature, pressure or humidity, let it acclimatise for 30 minutes before you use it. [. . . ] 3 minutes, the orange plug symbol goes out, while the battery symbol continues to flash. - AT893/AT890: When you start charging the empty battery, the charging light alternately flashes orange and green. Battery fully charged - AT891: When the battery is fully charged, the white battery symbol lights up continuously. - AT893/AT890/AT753/AT752/AT750: When the battery is fully charged, the charging light lights up green continuously. , The charging light shows the charging status of the shaver (see section `Charge indications' in this chapter). , The charging light shows the charging status of the shaver (see section `Charge indications' in this chapter). It can therefore not be used directly from the mains for safety reasons. Shaving tips and tricks - This shaver is suitable for both wet and dry use. Use the shaver with shaving gel or foam for extra skin comfort, or use the shaver dry for extra convenience. Note:We advise you to use the shaver with shaving gel or foam when you use it for a wet shave. - Your skin may need 2 or 3 weeks to get accustomed to the Philips shaving system. Note: If the shaving unit does not close smoothly, check if you have inserted the shaving heads properly and if the retaining frame is locked. Cleaning the trimmer with the cleaning brush (AT891/AT893/AT890 only) Clean the trimmer every time you have used it. Tip: For optimal trimming performance, lubricate the trimmer teeth with a drop of sewing machine oil every six months. Storage There are several ways to store the shaver or to take it with you when you travel: - Always put the protection cap on the shaver to prevent damage. Replacement For maximum shaving performance, we advise you to replace the shaving heads every year. Only replace the shaving heads with original HQ9 Philips Shaving Heads (for AT891) or HQ8 Philips Shaving Heads (for AT893/AT890/AT753/AT752/ AT750). Disconnect the shaver from the mains or remove it from the charging stand (AT891 only). Make sure that the projections of the shaving heads fit exactly into the recesses. 6 Put the retaining frame back into the shaving unit and turn the lock clockwise. 7 Insert the lug of the shaving unit into the slot in the top of the shaver (1). Note: If the shaving unit does not close smoothly, check if you have inserted the shaving heads properly and if the retaining frame is locked. [. . . ] Make sure the rechargeable battery is completely empty when you remove it. 1 Disconnect the shaver from the mains or remove it from the charging stand (AT891 only). Do not connect the shaver to the mains again or put it back into the plugged-in charging stand (AT891 only) after you have removed the rechargeable battery. Guarantee and service If you need service or information or if you have a problem, please visit the Philips website at www. [. . . ]