User manual PHILIPS HF3485

[. . . ] To fully benefit from the support that Philips offers, register your product at www. The light intensity of the lamp gradually increases to the set level in the set sunrise simulation time (the default time is 30 minutes). To make waking up an even more pleasant experience, you can use natural wake-up sounds, the FM radio or even downloaded sounds or your own music from a USB stick. The effects of the Wake-up light The Philips Wake-up Light gently prepares your body for waking up during the last 20 to 40 minutes of sleep, depending on the sunrise simulation time you set. [. . . ] 1 Follow the instructions in section `Menu functions' above and select the alarm sound function. You can choose one of the following sounds: - Radio (see also section `Using the radio as alarm sound' below') (Fig. 20) - Downloaded wake-up sounds or your own music from a USB stick (see also section `Using music on a USB stick as alarm sound' below). Using the radio as alarm sound 1 Follow instructions 1-4 in section `Setting the alarm sound' to select the radio as alarm sound. If you want to select another preset radio station, press the menu - or + button (see section `Using the radio/playing music from a USB stick'). If you want to change the frequency of the preset radio stations, see section `Using the radio/playing music from a USB stick' in this chapter) 2 Press the SELECT button to confirm. Using music on a usB stick as alarm sound Note:You can only use music on a USB stick if it is in MP3 or WMA format. 2 Follow instructions 1-4 in section `Menu functions' above to select music from a USB stick as alarm sound. Setting the sunrise simulation time The sunrise simulation time is the time in which the light intensity of the lamp gradually increases to the set level before the alarm sound is played. The default sunrise simulation time is 30 minutes, because this is the optimum time for your body to prepare for waking up. As the sensitivity to light differs from person to person, it is possible to adjust the sunrise simulation to your own preference. you can reduce the sunrise simulation time to 20 or 25 minutes or increase it to 40 minutes. 1 Simultanuously press and hold the light intensity increase and decrease buttons for 3 seconds (Fig. Snoozing 1 Tap on the surface of the Wake-Up light with the inside of your hand to snooze the appliance (some force needs to be applied to prevent accidental snoozing) (Fig. , The lamp continues to be on at the selected intensity level, but the alarm sound stops. Switching the alarm function off and on 1 To switch off the alarm function when the alarm goes off, push down the control lever to the bottom position (Fig. Note:The songs are ordered based on the date that the music was put on the USB stick. If you want the songs to be played in a specific order, put them in this order on your computer first and then copy them to your USB stick. Setting the volume 1 To set the volume for the radio or music from a USB stick, press the volume increase or decrease button. Note:The volume level you have selected is automatically set as the volume level for the alarm as well. Sunset simulation You can use the sunset simulation when you want the light and/or the sound of the Wake-up Light to stay on and dim gradually during a set period of time (15 minutes to 1. Note:The light intensity you set for the start of the sunset simulation is also used as the light intensity for the sunrise simulation See sections `Using the appliance as a bedside lamp' and/or `Using the radio/playing music from a USB stick' in this chapter. [. . . ] Perhaps you switched off the alarm function by setting the control lever to the bottom position. Perhaps you set a volume level and/or light intensity level that is too low. Solution Perhaps there was a power failure that lasted more than approximately 15 minutes. I wanted to snooze, but You probably pushed down the control lever to bottom position. [. . . ]