User manual PHILIPS RQ12

[. . . ] To fully benefit from the support that Philips offers, register your product at www. Please read this user manual, as it contains information about the features of this shaver as well as some tips to make shaving easier and more enjoyable. 1) A 1 2 3 4 5 6 7 B C 1 2 3 4 5 6 D E F G Shaver (RQ1290/RQ1280/RQ1260/RQ1250) Trimmer Trimmer on/off slide Shaving unit Protection cap Shaver Shaver on/off button Display Charger Jet Clean System (RQ1008/RQ1007) (specific types only) Shaver holder 'Cleaning chamber empty' symbol Cleaning symbol Drying symbol Jet Clean System on/off button (RQ1008 only: and up/down button for program selection) Cleaning chamber release button Cleaning brush Cleaning fluid Pouch Adapter important Read this user manual carefully before you use the appliance and save it for future reference. note: In this user manual the term `appliances' refers to the shaver and the Jet Clean System. [. . . ] Your skin may need 2 or 3 weeks to get accustomed to the Philips shaving system. , The display lights up for a few seconds and then shows the remaining battery capacity. Wet shaving You can also use this shaver on a wet face with shaving foam or shaving gel. To shave with shaving foam or shaving gel, follow the steps below: 1 Apply some water to your skin. 3 Rinse the shaving unit under the tap to ensure that the shaving unit glides smoothly over your skin. Note: Rinse the shaver under the tap regularly to ensure that it continues to glide smoothly over your skin. 6 Dry your face and thoroughly clean the shaver after use (see chapter `Cleaning and maintenance'). Trimming You can use the trimmer to groom your sideburns and moustache. , The display lights up for a few seconds and shows the remaining battery capacity. Cleaning and maintenance Never use scouring pads, abrasive cleaning agents or aggressive liquids such as petrol or acetone to clean the shaver and the Jet Clean System (specific types only). The best and most hygienic way to clean the shaver is in the Jet Clean System (specific types only). You can also rinse the shaver under the tap or clean it with the cleaning brush supplied. Always check if the water is not too hot, to prevent your hands from getting burnt. Always check if the water is not too hot, to prevent your hands from getting burnt. 3 Rinse all three shaving heads and all three hair chambers under a hot tap for 30 seconds. 28) Note:You can also brush the shaving heads and hair chambers with the cleaning brush supplied. Always check if the water is not too hot, to prevent your hands from getting burnt. 4 Carefully shake off excess water and leave the shaving heads open to let the shaving unit dry completely. Never dry the shaving unit with a towel or tissue, as this may damage the shaving heads. Cleaning the shaving unit in the Jet clean system (specific types only) The Jet Clean system comes in two types: - Type RQ1008 has three cleaning programs: the eco program, the auto program and the intensive program. When you press the on/off button, the Jet Clean System starts cleaning in the automatic cleaning program. 30) preparing the Jet clean system for use Fill the cleaning chamber before first use. [. . . ] Problem The shaver is not entirely clean after I clean it in the Jet Clean System. If the fluid volume in the cleaning chamber drops below the minimum level during the cleaning program, the program aborts. The cleaning light and the `cleaning chamber empty' symbol flash at intervals and the holder returns to its starting position. You have used another cleaning fluid than the original Philips cleaning fluid. [. . . ]