User manual SONY CDP-X505ES
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual SONY CDP-X505ES. We hope that this SONY CDP-X505ES user guide will be useful to you.
Manual abstract: user guide SONY CDP-X505ES
Detailed instructions for use are in the User's Guide.
[. . . ] If you do, the speakers may be damaged when a peak level portion is played. Clean the cabinet, panel and controls with a soft cloth slightly moistened with a mild detergent solution. Do not use any type of abrasive pad, scouring powder or solvent such as alcohol or benzine. Before operating the player, check that the operating voltage of the player is identical with your local power supply. [. . . ] The disc tray closes and the player plays all the tracks once (Continuous Play). Pause Resume play after pause Go to the next track Go back to the preceding track Stop play and remove the CD You can check information about the disc using the display. While playing a disc, the display shows the current track number, index number, playing time and the music calendar. The track numbers in the music calendar disappear after they are played. Each time you press TIME while playing a disc, the display changes as shown in the chart below. Checking the total number and playing time of the tracks press TIME before you start playing. The display shows the total number of tracks, total playing time and music calendar. Playing time and number of the current track Press Total number of tracks Music calendar Total playing time Remaining time on the disc While in Shuffle Play mode ("SHUFFLE" appears in the display; see page 9), a one-second access time blank is added between each track. This increase is automatically added to the total playing time in the display. The information also appears when you press § OPEN/CLOSE to close the disc tray. Each time you press DISPLAY ON/OFF on the remote while playing a disc, the display turns off and on alternately. Last programmed track Total playing time Track numbers being programmed Last programmed track Total playing time To select a track with a number over 10 If you've made a mistake Press CLEAR, then press the correct track number. If you've made a mistake Repeat Steps 2 and 3 to programme the tracks in the order you want. The programme remains even after the Programme Play ends When you press (, you can play the same programme again. You can record the programme you've created on a tape, DAT or MD. By inserting a pause during programming, you can divide the programme into two for recording on both sides of a tape. You can check the total playing time while programming using the remote (Programme Edit) To select a track, press = or + and check the total playing time. The total playing time doesn't appear in the display when it exceeds 100 minutes. ⷠ"FULL" appears in the display when you try to add a track to a programme which already contains 24 tracks. Each time you press this button, the display shows the track number in the programmed order. After the last track in the programme, the display shows "End" and returns to the original display. If you check the order after you start playing, the display shows only the remaining track numbers. [. . . ] The programme can contain up to 24 tracks (a pause inserted between tracks is counted as one track). Note that tracks whose numbers are over 24 cannot be programmed automatically. When you record on both sides of the tape, press EDIT/TIME FADE again. When you record on one side of the tape or on a DAT or MD, skip this step. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE SONY CDP-X505ES
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual SONY CDP-X505ES will begin.