User manual SONY HT-ST3

[. . . ] If your TV supports the ARC function, you do not need to connect the digital optical cable (supplied). Notes • To output multi-channel digital audio, check the digital audio output setting on the device connected to the system. 7 Turning on the system / Encendido del sistema 2 1 Insert the batteries (supplied). [. . . ] * When the display is turned from Off to On, audio format information appears on the display. ΐ SW TONE (page 10)  SW VOL (subwoofer volume) +/–  MENU/RETURN///ENTER (page 16)  SW TONE (página 10)  SW VOL (volumen del altavoz potenciador de graves) +/–  MENU/RETURN///ENTER (página 16) 15 Adjusting the settings / Ajuste de la configuración Press MENU on the remote control, then select the desired setting using //ENTER/RETURN. menu Function Default LEVEL DRC (DYNAMIC RANGE CONTROL) SYNC (AV SYNC) DUAL (DUAL MONO) S. OPT (SOUND OPTIMIZER) HEQ (HARMONICS EQUALIZER) AAV (ADVANCED AUTO VOLUME) CTRL (CONTROL FOR HDMI) You can enjoy Dolby Digital sound at low sound volumes. (ON/AUTO/OFF) ON: Compresses sound in accordance with the compression information contained in the content. You can adjust the sound when the image and the sound are not in sync. (1 – 4/ OFF) You can enjoy multiplex broadcast sound of Dolby Digital audio. (M/S (main and sub channels)/MAIN (main channel)/SUB (sub channel)) Adjusts the sound so that it is reproduced dynamically and more clearly even at low sound volumes. (ON/OFF) Reproduces the very low volume sounds that tend to be eliminated by audio compression. (ON/OFF) Note: HEQ functions only when “ANALOG/BT AU” is selected. This does not function with any other inputs, even though the item is displayed on the front panel. Reduces the volume discrepancies between different programs or between programs and commercials. Sets the power saving mode of the pass-through function of HDMI signals. (AUTO/ON) AUTO: Outputs signals from the HDMI OUT ARC (TV) jack of the system in standby mode when the TV is turned on. This setting saves power in standby mode compared with the “ON” setting. € Allows you to listen to digital sound from a TV compatible with the Audio Return Channel (ARC) technology is connected using an HDMI cable. [. . . ] € Make sure this system is located not too far from the BLUETOOTH device, or the system is not subject to interference from a Wi‐Fi network, other 2. € You may need to cancel the pairing with this system using your BLUETOOTH device first. No sound or only a very low-level sound of the connected equipment is heard from the system. [. . . ]