User manual SONY MDX-C670RDS

[. . . ] If no power is being supplied to the unit, check the connections first. If no sound comes from the speakers of the two-speaker system, set the fader control to the centre position. If your car is equipped with a power aerial, it will extend automatically while the unit is operating. If you have any questions or problems concerning your unit that are not covered in this manual, please consult your nearest Sony dealer. [. . . ] Note If the automatic tuning stops too frequently, press (MENU), then press either side of (DISC/PRST) repeatedly until "Local" (local seek mode) is displayed. tips · When you select the "Local on" setting, "LCL Seek" appears while the unit is searching for a station. If you know the frequency of the station you want to listen to, press and hold either side of (SEEK/AMS) until the desired frequency appears (manual tuning). Here are just a few: returning the same programme automatically, listening to traffic announcements, and locating a station by programme type. notes · Depending on the country or region, not all of the RDS functions are available. RDS may not work properly if the signal strength is weak or if the station you are tuned to is not transmitting RDS data. Each time you press (DSPL/PTY), the item changes as follows: Station Name (Frequency) y Programme type Tip The Motion Display mode can be turned off. By using this function, you can continuously listen to the same programme during a longdistance drive without having to retune the station manually. The unit starts searching for an alternative station with a stronger signal in the same network. Note The "*" indication means that an RDS station is being received. Note When there is no alternative station in the area and you do not need to search for an alternative station, turn the AF function off by pressing (AF) repeatedly until "AF off" appears. To cancel all traffic announcements, turn off the function by pressing (TA) until "TA off" appears. When you preset RDS stations, the unit stores each station's data as well as its frequency, so you don't have to turn on the AF or TA function every time you tune in the preset station. You can select a different setting (AF, TA, or both) for individual preset stations, or the same setting for all preset stations. You can locate the station you want by selecting one of the programme types shown below. Press (MENU), then press either side of (DISC/PRST) repeatedly until "BTM" appears. Presetting different settings for each preset station " Press the desired number button ((1) to (6)) until "MEM" appears. Tip If you want to change the preset AF and/or TA setting after you tuned the preset station, you can do so by turning the AF or TA function on or off. Note You cannot use this function in some countries where no PTY (Programme Type selection) data is available. "- - - - -" appears if the received station is not an RDS station, or if the RDS data has not been received. During radio reception, press (MENU), then press either side of (DISC/PRST) repeatedly until "CT" appears. When the unit finds the programme, the programme type appears again for five seconds. [. . . ] After the mode setting is complete, the display returns to normal playback mode. Warning Never use a fuse with an amperage rating exceeding the one supplied with the unit as this could damage the unit. The unit may not function properly if the connectors between the unit and the front panel are not clean. In order to prevent this, open the front panel by pressing (OPEN), then detach it and clean the connectors with a cotton swab dipped in alcohol. [. . . ]