User manual STANTON SK-2

[. . . ] Remove the fader to be cleaned by unscrewing the 2 outer screws (removing the 2 inner screws will detach the fader from the fader plate) and disconnect the cable coming from the mixer. Spray a small amount of cleaner or lubricant into both ends of the fader and slide the fader back and forth a few times to spread the fluid evenly throughout the fader. Shake and wipe off excess fluid before re-assembling the fader. SK TWO Professional performance mixer R E P L AC E M E N T PA RT S To replace the cross or channel faders, follow steps 1 and 2 of the cleaning instructions. The following replacement parts are available from Stanton or your local Stanton dealer. PL-SK2 3PL-SK2 LF-SK2 CF-SK2 Two way input toggle switch Three way input toggle switch with FLASHTM Channel input fader Crossfader PP-SK2 PS-18US PS-18EU PS-18UK PROTEKTTM panel US Power Supply (110v) European Power Supply (220v) UK only Power Supply (240v) ROTATING AND REPLACING THE INPUT TOGGLE SWITCHES ROTATING INST RU C TI O NS 1 . [. . . ] No power. Amplifier or outboard gear connected to the record output. Improperly connected AC cord or power line source not on. · Follow all security advice printed on your mixer · When removing the unit's AC plug from the power source, grasp and pull the plug, NEVER the cord itself!· Avoid placing your mixer near heat sources, such as power amplifiers. · When in use, place your mixer on a stable surface, away from vibration. Impact, or heavy vibration may compromise the unit's mechanical integrity. The manufacturer is not responsible for damage resulting from an impact, or misuse. · When in use, place your mixer away from sources of hum or noise, such as transformers, or electric motors. · To prevent overheating, always provide your mixer with adequate ventilation air space. · To avoid damage due to AC voltage peaks, always disconnect your mixer from the power source during electrical storms. The manufacturer is not responsible for any damage or personal injury resulting from unauthorized user-servicing or modifications. In addition, the warranty will be void if any unauthorized service by the user is detected. Always return you mixer to an authorized Stanton dealer for servicing. The amplifier is turned up, but there is no signal. Faulty output connections Improper level adjustment. No signal in headphones. Improper connection. Improper level or cue mix settings. D E S C R I P T I O N O F FU N C TI O N S 1. Mic EQ: Individual controls for low frequency, midrange, and high frequency equalization with (+/-12 dB) Any changes made to EQ settings will change the overall microphone output level. Mic pan control: Controls left/right output balance of the microphone. EQ: Individual controls for low frequency, midrange, and high frequency equalization with (+9/-26 dB) Any changes made to EQ settings will change the overall output level. It is recommended headphones with an impedance rating of 200 ohms or less be used for maximum volume. Cue select: In "CUE" position, the pre-selected signal of control (10) will be monitored as a stereo signal in the headphones. In "MASTER" position, the pre-selected signal of controls (7) and (18) will be monitored as a stereo signal in the headphones. Cue pan: Fades the headphone output between channels 1 and 2, effectively allowing the user to preview a mix. Input Fader Reverse: Reverses the direction of each respective input channel fader. [. . . ] FOR THE WARRANTY TO BE VALID, PLEASE COMPLETE THE ONLINE WARRANTY REGISTRATION FORM FOUND AT WWW. STA N TO N M AG N E TI CS . CO M 2821 Evans Street · Hollywood, FL 33020 cut for scratching and cutting to a longer fade for mixing. Ground connector: Connects to the turntable ground connector to eliminate electrical hum. Power supply connector: Input connection for the accompanying power supply. [. . . ]