User manual STANTON T.62

[. . . ] If you are unable to insert the plug fully into the outlet, try reversing the plug. If the plug should still fail to fit, contact your electrician to replace your obsolete outlet. Power-Cord Protection ­ Power-supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them, paying particular attention to the cord in correspondence of plugs, convenience receptacles, and the point where they exit from the appliance. Cleaning ­ The appliance should be cleaned only as recommended by the manufacturer. [. . . ] The T. 62 is built upon Stanton's heritage of designing audiophile products for the most discriminating listener. Before assembling the T. 62 please check to make sure the following items are included with the main unit in the carton. AC cord RCA cable 45 rpm adaptor Counter weight Cloth dust cover Platter Slipmat Stanton 500. V3 Cartridge pre-mounted on headshell, except on model T. 62X, no cartridge included User Manual Target light After confirming that all of the above parts are included in the box, its time to assemble the turntable. 1) Remove the platter from its protective wrapping and place on the spindle of the main unit. 2) Remove the slipmat from its protective wrapping and place on the platter. 4) If desired place the 45rpm adaptor in its allocated holder on the main unit. PLACEMENT - Do not place the unit in a location where it will be exposed to direct sunlight or near a heating appliance. - Do not place the unit in a location where there is high humidity or a lot of dust. - Cartridge may pick up slight sound pressures or vibrations from the speakers coming along the floor or through the air resulting in feedback. - The legs have functions for adjusting the height of the unit itself. Adjust the legs to stabilize the main body horizontally. CONNECTIONS To properly connect your T. 62, please follow these simple instructions: 1. Connect the RCA cable from the T. 62 Phono Output to your DJ Mixer Phono input. Connect the ground cable from the T. 62 ground post to your DJ Mixer ground terminal. . 5 . 3 0 0. 5 0 3 . 5 3 0 5 TONEARM AND CARTRIDGE SETTING The major cause of problems in sound and skipping on the vinyl is the lack of proper set up of the needle and turntable adjustments. The T. 62 has two adjustments to correctly position the needle to the vinyl. The first adjustment is the installation of the cartridge-head-shell assembly into the tone arm tube lock. The T. 62 includes a Stanton 500 V3 cartridge pre-mounted to the headshell. Holding the tone arm tube in one hand, insert the cartridge-headshell into the tube lock with the other hand. Turn the lock ring clockwise (when viewed from the rear) until the headshell is locked tightly into the tone arm. Remove the needle protector from the cartridge and place the needle on record. View the needle from the front and insure that the needle is perpendicular to the record surface. If some adjustment is needed, simply loosen the lock ring and rotate the cartridge headshell until the needle is perpendicular to the record surface. Then re-tighten the lock ring. Locking Ring CONNECTIONS 1 2. [. . . ] Stanton assumes no risk and shall be subject to no liability for damages or loss resulting from the specific use or application made of the merchandise. Stanton's liability for any claim, whether based on breach of contract, negligence, infringement of any rights of any party, or product liability, and relating to the merchandise shall not exceed the price received by Stanton from your purchase of such merchandise. In no event will Stanton be liable for any special, incidental or consequential damages (including loss of use, loss of profit and claims of third parties) however caused, whether by the negligence of Stanton or otherwise. To the extent permitted by law and except as otherwise provided above, Stanton disclaims any express or implied warranties of merchantability or fitness for a particular purpose. [. . . ]